Outstanding Resistance to U. V. degradation
Excellent weather resistance
Superior abrasion resistance
Excellent resistance to water, alcohol, dilute acids & alkalies
On drying yield hard film with high gloss
Water Clear viscous liquid
Acrylic Polymer in organic solvent
High gloss, Hard Clear film
Can be diluted with conventional solvents, i.e. xylene, toluene to desired viscosity
Store away from heat source as it is highly inflammable
50 ltr/200 ltr. containers
Kwikfast-1000 is a Superplasticizers Powder based on sulphate melamine poly condensate polymer. It is high range water reducer. It gives excellent early and high ultimate strength.
|Water reduction of more than 20% achieved, eventually increasing the ultimate strength of concrete.|
|Improves the early strength and gives easier demolding|
|Increases the density of concrete.|
|Reduces transportation cost by almost 2.7 times|
|Physical properties||White free flowing powder|
|Chemical contents||Melamine polymer|
|pH (10% solution)||8 – 10|
|Dry material contents||95±2%|
|Bulk Density||500 ± 100 kgs/m3|
|Chloride contents||<0.05 %|
The doses of Kwikfast-1000 depend on the required final results at each site. Generally a dosage of 0.2%-2% of the cement shows very good results. Preliminary trials should be conducted at the job-site to determine optimum dosage.How to Mix: Kwikfast-1000: - Take one kg Powder add into 1.7 kg water and mixed with help stick/wooden article then 2.7 Kgs Superplasticiser become ready for use
For each Bag of Cement of 50 Kgs the above ready mixture of 250 grams to be used for utilization. This is for your convenient use.
Shelf life: 12 months in normal ambient conditions, stored under a roof.
Add the Following: Whenever 25 kg Poly bags opened for use it should be consumed on the same day & time otherwise it will become damped & other damages can due to ambient temperature.
Mode of Packing: 25 kgs
KWIKFAST – 600 is new generation Melamine Resin based effective superplasticizer for concrete. It is a high range water reducing admixture and gives very high early and ultimate strength to the concrete. It increases the workability of concrete mix and lowers the water requirement that leads to a concrete of higher compressive strength and improved durability.
|Water reduction of more than 20% achieved, eventually increasing the ultimate strength of concrete|
|Improved workability of concrete.|
|High early strength of concrete achieved|
|Extremely good dispersion helps in uniform distribution of strength thus leading to lesser breakage|
|Faster and easy de-molding of rubber as well as PVC moulds for blocks|
|Reduced air pockets and pinholes|
|Excellent compaction of concrete|
|Shrinkage control of concrete is achieved because of reduced water.|
|Physical properties||Colourless to slightly hazy liquid|
|Chemical contents||Melamine Resin|
|Ph||7 - 8|
1) Faster demolding, higher strength and almost zero breakage in paving tiles and blocks.
2) Reduced bleeding of cement, excellent finish and reduced air pockets in RCC spun pipes.
3) Molds can be released at a much faster rate in electric poles and railway sleepers.
The doses of Kwik Fast-600 depend on the required final results at each site. Generally a dosage of 0.5%-1.5%of the cement shows very good results. Initial trials must be taken at the job-site to determine optimum dosage.
Instructions for use:KWIKFAST–600 should be added only after thoroughly mixing cement, sand, coarse aggregates and water. After addition of Kwik Fast-600, the concrete must again be thoroughly mixed for one minute so as to achieve a uniform consistency of concrete mix. Kwik Fast-600 could be mixed with the gauging water itself.
Shelf life: 12 months in normal ambient conditions, stored under a roof..
Packing:50 kgs containers.